LUXI LUXI Integrated Polishing System
EN
ENEnglishRUРусскийTHไทยIDBahasa IndonesiaVITiếng ViệtHIहिन्दीJA日本語

Troubleshooting

Brush does not hold compound

The brush reaches the recess but does not carry enough active compound into the contact zone.

A small brush with nearly bare fibre tips and loose compound-like dust on the nearby work surface.

Symptoms

  • Brush appears clean or dry immediately after charging.
  • Recess contact happens, but the surface does not brighten.

Likely causes

  • The brush is too stiff, too dirty or not holding compound.
  • The contact zone does not generate enough working heat for standard polishing-paste behaviour.
  • Too much pressure may push compound away instead of transferring it.

Checks

  • Check whether compound remains on the bristles after a short pass.
  • Check whether a lighter charge transfers better.
  • Compare with LUXI Purple behaviour on the same brush.

Recommended fixes

  • Clean the brush and apply less compound.
  • Use LUXI Purple as the primary brush-route compound.
  • Use shorter passes and lighter pressure.
  • If the recess remains rough rather than just dull, consider whether a short stiff brush route is required.

Prevention

  • Develop brush routes separately from standard wheel routes.
  • Record brush type, compound amount and contact behaviour.